Embedding Accessories
Electron Microscopy Sciences Aluminum Base Mold, 50 x 50 x 30 mm
This extra large square base mold offers optimal thermal conductivity. Features a well polished surface for easy block removal. It will accommodate most samples.
Electron Microscopy Sciences Paraffin TMA Arraymold Kit B, Blue, 1.5 mm diameter, 150 cores per mold Capacity
The Arraymold is the simple tool for laboratories to perform Paraffin tissue microarrays (TMAs) w/ less time while maintaining excellent results. Process up to 150 specimens onto one single slide w/ very little time consuming, minimal technical training. The DVD instruction is accompanying w/ each kit, will step by step guide you to perform through the entire TMAs process. Arraymolds allow pathologist or researcher to view many different samples on the same single slide. Helpful in finding IHC markers for control or quality assurance from hundreds of samples. Staining markers will be more consistent when hundreds of samples are on one slide. Used less costly antibody.Arraymold kit is small enough to be stored in a drawer.Rubber arraymold can be reused many times without losing its flexibility. Generates 1.5 mm diameter sample core, 150 cores per mold. Kit: 10 Disposable 2mm sterile dermal needles, 2 Stylets, 1 Brass Plate, 1 1.5mm reusable rubber Arraymold, DVD.Color: Blue
Electron Microscopy Sciences Microtome Thick Embedding Stubs, 10 mm
Block holder molded from hard plastic. Easy to store block holders attached to Aluminum chucks (ABH). Frosted surface for easy marking. Large center hole prevents bubble formation.
Size: 10 mm
Electron Microscopy Sciences Capsule Mold Type C, 12 Cavities
Our molds are made from the strongest possible silicone rubber providing extremely high tear resistance. The molds are are reusable. Type C has 12 cavities cylindrical shapes, 8mm diameter 16mm height, flat tip.
Electron Microscopy Sciences Mold for Cell Culture
This mold is designed primarily for embedding cell culture specimens grown either directly on the bottom of a dish or on the filter when cross sections of the cells are needed. Cells grown on petri dishes are cut into strips just before the propylene oxide dehydration step; when Propylene Oxide is added, the strips lift right off the bottom. When the strips are ready for embedment, they are rolled on an applicator stick into a wad and gently lowered into the well (the strips should not float).
Advatages
Many cells can be examined in cross section.
There is no need for trimming.
The curved side makes the tip very strong in spite of its thinness.
Easy detection of a strip of cells.
The label is placed on the round part so as not to interfere with the specimen.
24 cavities.
Electron Microscopy Sciences EMS EMS Poly III Evaporation-Controlled Automated Embedding and Polymerization
The EMS Poly III reduces lengthy and sometimes tedious manual embedding procedures for electron microscopy to a few simple steps for up to 52 vials. It uses a proper combination of pressure and temperature. The specimen chamber is temperature controlled from room temperature to 70 degree C. The pressure in the chamber can be reduced from ambient pressure with an inbuilt vacuum-pump that controls pressure to within narrow limits and warrants solvents will evaporate without the risk of explosive boiling. The exhaust of the vacuum pump can vent into a fume hood.
The instrument modifiable preset programs are optimized for an efficient removal of solvent from specimens eliminating the risk of boiling. Bulk removal of solvent is followed by the thorough removal of trace amounts.
Load at the end of a workday and (when using acetone or propylene oxide) the next morning are ready for polymerization after being topped off with pure resin.
Production Automation Corporation POLYPROPYLENE DSPSBL LAB MED
NC3871611 POLYPROPYLENE DSPSBL LAB MED